reset bios gigabyte h81m-ds2

The battery provides power to keep the values (such as BIOS configurations, date, and time information)

in the CMOS when the computer is turned off. Replace the battery when the battery voltage drops to a low

level, or the CMOS values may not be accurate or may be lost.

You may clear the CMOS values by removing the battery:

1. Turn off your computer and unplug the power cord.

2. Gently remove the battery from the battery holder and wait for one minute. (Or use a metal

4. Plug in the power cord and restart your computer.

Always turn off your computer and unplug the power cord before replacing the battery.

Replace the battery with an equivalent one. Danger of explosion if the battery is replaced with an incorrect model.

Contact the place of purchase or local dealer if you are not able to replace the battery by yourself or uncertain

When installing the battery, note the orientation of the positive side (+) and the negative side (-) of the battery

(the positive side should face up).

Used batteries must be handled in accordance with local environmental regulations.

12) CLR_CMOS (Clear CMOS Jumper)

Use this jumper to clear the BIOS configurations and reset the CMOS values to factory defaults. To clear

the CMOS values, use a metal object like a screwdriver to touch the two pins for a few seconds.

Always turn off your computer and unplug the power cord from the power outlet before clearing the CMOS values.

After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or manually

configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).

object like a screwdriver to touch the positive and negative terminals of the battery holder,

making them short for 5 seconds.)